ive bought a network cam and followed the instructions from the cd,but its packed up.?

ive bought a network cam and followed the instructions from the cd,but its packed up.?

Do it again...
enjoy you rebooted the machine?



Are adjectives the connections in correctly?



Did you catch any error messages?



Did it ask you to install the drivers?
assuming all cable are hooked up correctly and software installation did not work ...try add/remove hardware option contained by control panel. If that doesn't work cal manufacturer for secondary help or updates
first read the specs , is it compatable beside your operating system , if so does your machine congregate all minimum requirements? when you plug cam into usb slot does skylight pop up saying unmarked hardware found ? if not , its not recognize the cam or the usb slot . you need to see if adjectives drivers are loaded . install software and reboot with cam plugged surrounded by
tryy this one. Try replugging the USB cable in another USB slot. I presume you bought a unknown cam not a used one.



Like my Logitech Fusion, you have to download the driver WITH the cam disconnected. Then run the program, consequently connect it.